Configuring Re-Dhcp Portal Authentication - HPE FlexNetwork 7500 Series Security Configuration Manual

Portal status: Disabled
Portal authentication method: Disabled
Portal web server: Not configured
Authentication domain: Not configured
Pre-auth domain: Not configured
User-dhcp-only: Disabled
Pre-auth IP pool: Not configured
Max Portal users: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HPE iNode client or through a Web browser.
Before passing the authentication, the user can access only the authentication page
http://192.168.0.111:8080/portal. All Web requests from the user will be redirected to the
authentication page. After passing the authentication, the user can access other network resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
VPN instance: N/A
MAC
0015-e9a6-7cfe
Authorization information:
DHCP IP pool: N/A
ACL: N/A
CAR: N/A

Configuring re-DHCP portal authentication

Network requirements
As shown in
obtains an IP address through the DHCP server. A portal server acts as both a portal authentication
server and a portal Web server. A RADIUS server acts as the authentication/accounting server.
Configure re-DHCP portal authentication. Before passing the authentication, the host is assigned a
private IP address. After passing the authentication, the host gets a public IP address and can
access network resources.
Server name
--
IP
2.2.2.2
Figure 60, the host is directly connected to the switch (the access device). The host
VLAN Interface
100 Vlan-interface100
189
Action
--
Prefix length
Prefix length