HPE FlexNetwork 7500 Series Security Configuration Manual page 428
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (506 pages) ,
- Command reference manual (474 pages) ,
- Network management and monitoring command reference (430 pages)
Table of Contents
Advertisement
Configuration procedure
1.
Configure the DHCPv6 relay agent:
# Create VLAN 2 and VLAN 3, assign interfaces to the VLANs, and specify IP addresses for
VLAN-interface 2 and VLAN-interface 3. (Details not shown.)
# Enable the DHCPv6 relay agent on VLAN-interface 3.
[Switch] interface vlan-interface 3
[Switch-Vlan-interface3] ipv6 dhcp select relay
# Enable recording of DHCPv6 relay entries on the interface.
[Switch-Vlan-interface3] ipv6 dhcp relay client-information record
# Specify the DHCPv6 server address 2::2 on the relay agent.
[Switch-Vlan-interface3] ipv6 dhcp relay server-address 2::2
[Switch-Vlan-interface3] quit
2.
Enable IPv6SG on VLAN-interface 3 and verify the source IP address and MAC address for
dynamic IPv6SG.
<Switch> system-view
[Switch] interface vlan-interface 3
[Switch-Vlan-interface3] ipv6 verify source ip-address mac-address
[Switch-Vlan-interface3] quit
Verifying the configuration
# Verify that a dynamic IPv6SG binding is generated based on a DHCPv6 relay entry.
[Switch] display ipv6 source binding dhcpv6-relay
Total entries found: 1
IP Address
1::2
MAC Address
Interface
0001-0203-0406 Vlan3
414
VLAN Type
3
DHCPv6 relay
Advertisement
Table of Contents
Troubleshooting
