Enabling The Scp Server; Enabling Netconf Over Ssh; Configuring The User Lines For Ssh Login - HPE FlexNetwork 7500 Series Security Configuration Manual

Enabling the SCP server

After you enable the SCP server on the device, a client can log in to the device through SCP.
When acting as an SCP server, the device does not support SCP connections initiated by SSH1
clients.
To enable the SCP server:
Step
1. Enter system view.
2. Enable the SCP server.

Enabling NETCONF over SSH

After you enable NETCONF over SSH on the device, a client can perform NETCONF operations on
the device through a NETCONF-over-SSH connection.
When acting as a server in the NETCONF-over-SSH connection, the device does not support
connection requests initiated by SSH1 clients.
To enable NETCONF over SSH:
Step
1. Enter system view.
2. Enable NETCONF over
SSH.

Configuring the user lines for SSH login

Depending on the SSH application, an SSH client can be an Stelnet client, SFTP client, SCP client,
or NETCONF-over-SSH client.
Only Stelnet and NETCONF-over-SSH clients require the user line configuration. The user line
configuration takes effect on the clients at the next login.
To configure the user lines for Stelnet and NETCONF-over-SSH clients:
Step
1. Enter system view.
2. Enter VTY user line view.
3. Set the login authentication
mode to scheme.
Command
system-view
scp server enable
Command
system-view
netconf ssh server enable
Command
system-view
line vty number [ ending-number ]
authentication-mode scheme
312
Remarks
N/A
By default, the SCP server is
disabled.
Remark
N/A
By default, NETCONF over SSH is
disabled.
For more information about
NETCONF over SSH commands,
see Network Management and
Monitoring Command Reference.
Remarks
N/A
N/A
By default, the authentication
mode is password.
For more information about this
command, see Fundamentals
Command Reference.