Mounting Control Modules; Setting Mp40 Module Switches And Mounting Optional Modules; Table 3.2 Components On The Rear Panel Of Chassis - Samsung OfficeServ 7400 Installation Manual

Functions of components on the rear panel of the chassis are shown in Table 3.2.
No. Component
1 Ground Lug
2 Connector for External Rectifier
3 Handle
4 Fuse Holder
5 AC LED
6 DC LED
7 Battery Socket
8 Power I/O Connector
9 Power Switch
10 Battery Switch

3.2 Mounting Control Modules

This section describes the procedures for setting switches, adding optional modules,
mounting modules in slots, and connecting MP40 and LP40 modules.
Check all modules carefully for damage before you mount them. If damage is evident, do
not continue with the installation and contact your dealer for advice.
3.2.1 Setting MP40 Module Switches and Mounting Optional
Modules
The MP40 module has switches for optimizing the module for users' requirements. The
procedure for setting switches and mounting optional modules is as follows:
1) Set the S1 switch of the MP40 module to 'on'.
2) Set SW1 to SW5 of the S2 switch to 'off'.
© Samsung Business Communications

Table 3.2 Components on the Rear Panel of Chassis

Lug for grounding system communication
To supply external power for PoE (Power over Ethernet)
To use while mounting/removing a power module
Fuse for AC input power
The LED turns on while applying AC power.
The LED turns on while the DC power is operating.
Socket to connect an external battery
Connector for power cable
System power switch
Switch to supply battery power to the OfficeServ 7400 or
charge the battery.
OfficeServ 7400 Installation Guide
Function
3-3