Chapter 8. Starting The System - Samsung OfficeServ 7400 Installation Manual

CHAPTER 8. Starting the System

8.2 Starting the System
1) Check that all required modules and cables are properly mounted and connected to the
OfficeServ 7400 chassis.
2) Switch on the power to the OfficeServ 7400 basic chassis, and then switch on the
power to the expansion chassis.
3) Check the LEDs of the MP40 and LP40 modules.
The RUN LED on the MP40 module lights green and the SM LED flashes when
the system starts the booting process.
Once booting is complete, the RUN LED on the MP40 module flashes green, and
the SM LED stops flashing and lights steady.
The RUN LED on the LP40 module flashes when the power supply and processor
status of the expansion chassis is normal.
4) Check that the LED statuses of other interface modules are normal.
5) If the LED status of a MP40, LP40 or interface module is abnormal, switch off the power
to the chassis and switch it on again.
8-2
If the Smart Media card is not detected
If the system cannot detect the Smart Media card, the SM LED of the MCP mod-
ule might not light or flash. In such cases, switch off the power to the basic chas-
sis, replace the Smart Media card and switch the power on again.
Module LED Status and Shut-down
- Refer to the Samsung OfficeServ General Description for the LED statuses of
each module.
- Shut-down is rarely required while operating the OfficeServ system. However, if
shutting down the system for reasons such as moving it, switch off the power to
the expansion chassis first and then switch off the power to the basic chassis
© Samsung Business Communications.