Installing Chassis In A Rack; Precautions To Follow; Tools Required; Figure 2.2 Tools For Installation Inside A Rack - Samsung OfficeServ 7400 Installation Manual

CHAPTER 2. Installing Chassis

2.2 Installing Chassis in a Rack

This section describes how to install the OfficeServ 7400 chassis inside a 19-inch rack.

2.2.1 Precautions to Follow

Take the following precautions when installing the OfficeServ 7400 chassis inside a rack:
Use a standard 19-inch electric equipment rack.
When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to ventilate
cool air into the rack.
When using an open rack, do not block the entrance of a port or fan on the OfficeServ
7400 system.

2.2.2 Tools Required

A mid-sized cross-head screwdriver
A bracket and three screws for attaching to chassis
Two brackets, six screws, and six nuts for attaching to rack
Two clamp screws
2-2
Caution
Only trained service staff should install the OfficeServ 7400 system.

Figure 2.2 Tools for Installation Inside a Rack

© Samsung Business Communications