Mounting Interface Modules; Setting Switches And Mounting Optional Modules; Table 3.7 Interface Modules With Switches/Jumpers; Table 3.8 Interface Modules For Optional Modules - Samsung OfficeServ 7400 Installation Manual

CHAPTER 3. Installing and Replacing Modules

3.3 Mounting Interface Modules

This section describes how to set jumpers and switches on interface modules, how to
mount optional modules onto interface modules, and how to mount interface modules into
slots.

3.3.1 Setting Switches and Mounting Optional Modules

Interface modules used depend on the configuration required by the user.
Interface Module
GWIM
MGI
TEPRI
TEPRI2
PLIM
GPLIM
GSIM
Interface module
GWIM
MGI
3-12

Table 3.7 Interface Modules with Switches/Jumpers

Jumpers/Switches
J1~J2
Memory Backup Switch
S1(SW1~SW8)
S2(1~4)
S3(1~4)
J1~J3
J1~J4
J13~J14

Table 3.8 Interface Modules for Optional Modules

GWIMS
MGI2D
Functions
Selection of power source (-54 V)
- EXT: Supply of 54 V from an external PoE power
module
- INT: Supply of 54 V from the system power supply
Setup of memory setup
Setup of T1, E1, T1/E1, PRI, 24B+D/24B,
User/Network, 17H/13H
Setup of T1, E1, T1/E1, PRI, 24B+D/24B,
User/Network, 1AH
Selection of power source (-54 V) for PoE
- EXT: Supply of 54 V from an external PoE power
module
- INT: Supply of 54 V from the system power supply
Selection of power source (-54 V) for PoE
- EXT: Supply of 54 V from an external PoE power
module
- INT: Supply of 54 V from the system power supply
- Selection of power source (-54 V)
- EXT: Supply of 54 V from an external PoE power
module
- INT: Supply of 54 V from the system power supply
Optional Module
© Samsung Business Communications