GE 750 Instruction Manual page 300

15.2 PICKUP TEST
15.2 PICKUP TEST
The relay provides the ability to operate any or all of the output relays 3-7 AUXILIARY, upon the pickup of any
protection element. The pickup test feature is especially useful for automated testing. Through a 750/760 out-
put contact, test equipment can monitor a pickup threshold.
PICKUP TEST
[ENTER] for more
PICKUP TEST
FUNCTION: Disabled
PICKUP TEST
RELAYS (3-7): -----
15
15-
2
Courtesy of NationalSwitchgear.com
The setpoints path is:
PICKUP TEST
\ SETPOINTS \ S8 TESTING \ PICKUP TEST
Range: Enabled, Disabled
Select Enabled if the pickup of any sensing element, shown in Figure 15–1:
PICKUP TEST LOGIC DIAGRAM on page 15–3, is required to be directed to
an output relay. Note that this setpoint will always be defaulted to Disabled at
power up.
Range: Any Combination of the 3-7 AUXILIARY Relays
Select the required relays to signal an output when any of the protection ele-
ments, or any of the permitted monitoring elements, senses a parameter
above its pickup threshold.
750/760 Feeder Management Relay
15 S8 TESTING
15.2.1 DESCRIPTION
15.2.2 SETPOINTS
GE Power Management