Prior To Installing A Hygienic Single Rod Probe; To Install A Model 7Xf Or Model 7Xh; Single Hygienic Probe - Magnetrol eclipse Enhanced Model 705 Installation And Operating Manual

A
➀
➁ ➂
➄
One method for stabilizing probe
within a vessel
10

2.4.1 Prior to Installing a Hygienic Single Rod Probe

B
• Probe has adequate headroom for installation and has unob-
• Process temperature, pressure, dielectric, viscosity, and
• Nozzle length does not restrict performance by ensuring the
2.4.1.1 To install a Model 7xF or Model 7xH rigid single rod
➃
① Confirm the model and serial numbers on the nameplates
② Attach probe rod to process connection using soft jaw
Æ
Ø
∞ Place the transmitter on the probe. Align the universal
57-642 ECLIPSE Model 705 Guided Wave Radar Transmitter for Hygienic Industries
(Models 7xF and 7xH)
Before installing, ensure the:
structed entry to the bottom of the vessel.
media buildup are within the probe specifications for the
installation. See Specifications, Section 3.6.
following:
• Ratio of Diameter: Length (A:B) is 1:1 or greater; any
ratio, 1:1 (e.g., a 2" x 6" nozzle = 1:3) may require a
Blocking Distance and/or DIELECTRIC adjustment
• Probe is not in contact with conductive objects with
in the vessel.
hygienic probe:
of the ECLIPSE probe and transmitter are identical.
wrench [tighten to 20–25 inch-lbs. (2.25-3 Nm)].
Carefully place the probe into the vessel. Align the probe as
necessary on the vessel.
Remove the protective plastic cap from the top of the probe
and store for future use. Make sure the top probe connector
(female socket) is clean and dry. Clean with isopropyl
alcohol and cotton swabs if necessary.
connection at the base of the transmitter housing with the
top of the probe. Tighten the connection to 45 ft–lbs.