Sagitter QUIVER User Manual page 30

Effect window for pan and tilt:
To apply an effect to an attribute of the previously selected fixtures, proceed as follows:
1) In the editor select the desired fixtures.
2) Press 'Effects' button in the upper toolbar.
3) Select the parameter where the effect as to be applied, pressing one of the buttons on the
toolbars 1 and 3.
4) Select the minimum and maximum values of the wave-form by clicking on the palette
buttons or operating on the first two Touch Sliders.
5) With the linear and square buttons, it is possible to select the wave-form (respectively
sinusoid and square wave).
6) The third Touch Slider (Period) enables to vary the speed of the effect.
7) With the Phase buttons and the fourth Touch Slider the global effect can be adjusted.
These settings are effective only if the effects involve two or more fixtures.
8) Instead of using the Touch Sliders, it is possible to enter a parameter value also by means
of the keypad that appears pressing the correspondent screen button 6.
In case of simultaneous Pan and Tilt ('Pan+Tilt') the window is slightly different: instead of the
phase buttons there are the path buttons and the 'Left/Right' e 'Sync/No Sync' buttons, that allow
to obtain an effect similar to a chase.
30