Playing - Cue Execution - Sagitter QUIVER User Manual

To apply a palette to the selected fixtures you must press the 'Palette' button to show the palette
window and select the desired palette.
The user palettes are organized in six different sets: Intensity, Pan/tilt, Colors, Gobos, Prism, and
Blade buttons allow to show the corresponding palette set.
To create a new palette, you must set up the fixture in the show at the desired values, then save it
pressing one of the Intensity, Pan/tilt, Colors, Gobos, Prism, and Blade buttons in the 'Store' menu.
When a palette has been saved, only the correspondent parameters are stored (as example saving
a palette of Pan/Tilt type only the Pan/Tilt parameters are stored and all others are ignored).
Playing – cue execution
The cue-lists are arranged in 12 pages, each one containing 12 cue-lists. The registers allow to
interact with the cue list of the current page. By pressing a Register's switch, the first cue of the
cue-list linked to the Register is activated (example: pressing the key of Register 3 it plays the first
cue of the cue-list 3 of the current page). With the expansions it's possible to play also the cue-list
of the following pages, from the current to a maximum of 36 cue-lists.
Pressing again a Register key, the next cue is activated, and so on until the latest cue is reached,
then restarting from the first one. It is possible to associate to the first 6 registers a slider to
control the master Intensity or the master size or the master speed of the cue-list. Without a
physical slider, all other masters are fixed to 100%.
IMPORTANT: the EDITOR view has the priority over the registers, therefore a cue-list is not capable
to take the control of the channels controlled by the EDITOR. Typically, before starting to play the
cue-list it is recommended to clear the EDITOR (quick double pressing of 'Clear' switch).
When two cues fitted in two different registers challenge the same DMX channel, the following
criterion is applied:
‐ If the channel is set as LTP, the priority is for the cue played most recently.
‐
If the channel is set as HTP, the criterion LTP o HTP is applied (priority at the higher value)
as specified in the field 'Playback mode' in the 'General options'.
To turn off a cue-list you must press the 'Release' key and then quickly the register key or press
the register key while the 'Release' key is pressed. Pressing quickly two times the release key all
register stop playing (function 'Release all').
If you change the page, a new 12 cue-list set completely independent from the previous is
associated to the console 12 registers. To make the transition more 'gentle', the page changing
doesn't stop the registers currently playing: after the page change, the active registers continue to
control the cue-list of the previous page and only after the release the new cue-list will be
associated. Be careful because in this situation it could happen that cue lists of different pages are
playing simultaneously.
23