Acura 3.5 RL Manual page 605

Mainshaft
Sub-assembly
NOTE:
• Lubricate all parts with ATF during assembly.
• Before installing the O-rings, wrap the shaft splines
with tape to prevent damage to the O-rings.
• Assemble the mainshaft sub-assembly when assem-
bling the transmission.
• Refer to page 14-151
3rd gear, 4th gear, and 43 x 74 mm thrust washer.
Assemble the parts below on the mainshaft.
THRUST WASHER
THRUST NEEDLE
BEARING
THRUST WASHER,
43 x 74 mm
and 14-152, when installing the
SNAP RING
1ST GEAR
NEEDLE BEARINGS
THRUST NEEDLE BEARING
1ST GEAR DISTANCE COLLAR
1ST GEAR COLLAR
1ST/4TH CLUTCH
ASSEMBLY
O-RINGS
Replace.
THRUST NEEDLE BEARING
4TH GEAR
NEEDLE BEARING
THRUST NEEDLE BEARING
3RD GEAR
MAINSHAFT