Glass Height Adjustment - Acura 3.5 RL Manual

Troubleshooting
Symptom
Water leaks
Wind noise
Motor noise
Glass moves, but glass doss not stop tem-
porarily (between the fully open position and
the fully closed position)
Glass does not move, but motor turns
Glass does not move and motor does not turn
(glass can be moved with moonroof wrench)

Glass Height Adjustment

The roof panel should be even with the glass weather-
strip, to within 1.7 mm (0.07
around. If not, open the glass fully, and:
1.7 mm
(0.07 in.)
• ROOF PANEL
1. Remove the bracket cover.
2. Loosen the nuts, and install the shims between the
glass frame and glass bracket as shown.
Shim thickness: Max. 2 mm (0.08 in.)
3. Repeat on opposite side if necessary.
1.
Clogged drain tube.
2. Gap between glass weatherstrip and roof panel.
Defective or improperly installed glass weatherstrip.
3.
Gap between drain seal and roof panel.
4.
Excessive clearance between glass weatherstrip and roof panel.
1.
Loose motor.
1.
Worn gear or bearing.
2.
Cable assembly deformed.
3.
Control unit connector not connected properly.
1.
2. Defective limit switch.
Defective control unit.
3.
1.
Clutch out of adjustment.
Foreign matter stuck between guide rail and slider.
2.
3. Inner cable loose.
Cable assembly not attached properly.
4.
Blown fuse.
1.
2. Faulty switch.
Battery run down.
3.
4. Defective motor.
Faulty relay.
5.
in.) all the way
GLASS WEATHERSTRIP
GLASS
Probable Cause
SHIM
6 x 1.0 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft)
PLUG
SHIM
GLASS
BRACKET
6 x 1.0 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft)
BRACKET
COVER
Forward