Inspection - Acura 3.5 RL Manual

22. Check that the crankshaft pulley and camshaft pul-
leys are at TDC.
CRANKSHAFT PULLEY:
TDC MARK
(WHITE)
LEFT CAMSHAFT PULLEY:
UPPER COVER
POINTER
RIGHT CAMSHAFT PULLEY:
UPPER COVER
POINTER
INSPECTION HOLE
After checking,
install the rubber
cap.
LOWER COVER
POINTER
TDC MARK
(BLUE)

INSPECTION

HOLE
After checking,
install the rubber
cap.
TDC MARK
23. If the camshaft and crankshaft pulleys are not posi-
tioned at TDC, remove the timing belt and adjust the
positioning following the procedure on page 6-10,
then reinstall the timing belt.
24. After installation, adjust the tension of each belt.
See section 4 for alternator belt tension adjust-
ment.
See section 22 for A/C compressor belt tension
adjustment.
See section 17 for P/S pump belt tension adjust-
ment.