Trunk Pass-Through Cover Key Cylinder Replacement - Acura 3.5 RL Manual

Rear Seat

Trunk Pass-through Cover Key Cylinder Replacement

NOTE:
When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
Take care not to scratch the cover.
1. Using a flat-tip screwdriver, pry the rear seat handle
up at either hook portion on forward side of the
trunk pass through cover. Then slide the handle
half-way up.
TRUNK
PASS-THROUGH
COVER
HOOKS
From trunk compartment side of the cover, using a
small screwdriver, press the inside hook down
through the access hole.
TRUNK HANDLE
While pressing the hook, pry the trunk handle up
3.
with a flat-tip screwdriver.
REAR SEAT HANDLE
ACCESS
HOLE
HOOK
4. Remove the trunk handle and rear seat handle
together at the same time.
TRUNK
PASS-THROUGH
COVER KEY
CYLINDER
Forward
TRUNK
PASS-THROUGH
COVER
5. Remove the retainer clip, then remove the trunk
pass-through cover key cylinder from the cover.
6. Install the key cylinder in the reverse order of
removal, and note these items:
Put the two handles together before installing
them on the trunk pass-through cover.
Make sure the trunk pass-through cover opens
properly and locks securely.
REAR SEAT
HANDLE
TRUNK HANDLE
RETAINER
CLIP