Acura 3.5 RL Manual page 211

Illustrated Index
(cont'd)
Lubricate all internal parts with engine oil during reassembly.
NOTE:
• Apply liquid gasket to the mating surfaces of the rear
cover and oil pump case before installing them.
• Use liquid gasket. Part No. 08718 - 0001 or 08718 - 0003.
OIL PAN INNER
PIPE
Clean when installing.
OIL PUMP
Overhaul, page 8-12
Apply liquid gasket
to block mating surface.
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
CRANKSHAFT OIL
SEAL
Installation,
pages, 7-30 and 8-15
Replace.
OIL FILTER
O-RINGS
Replace.
DOWEL
PIN
O-RINGS
Replace.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
OIL PAN
Apply liquid gasket
to mating surface.
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
O-RING
Replace.
DOWEL
PIN
SNAP RING
Install with open
side facing up.
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
TORQUE CONVERTER
COVER
12 x 1.0 mm
74 N-m (7.5 kgf-m,
54 Ibf-ft)
DRIVE PLATE
Check for cracks.
CRANKSHAFT OIL
SEAL
Installation, page
Replace.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
REAR COVER
Apply liquid gasket to
block mating surface.
O-RING
Replace.
WASHER
7-22