Crankshaft
Installation (cont'd)
14. Tighten the oil pan bolts as shown.
OIL PAN BOLT TIGHTENING SEQUENCE
8 x 1.25 mm: 22 N-m (2.2 kgf-m, 16 Ibf-ft)
15. Apply engine oil to the balancer shaft, then insert
the balancer shaft.
NOTE: Take care not to damage the journals when
installing the balancer shaft.
BALANCER
SHAFT
16. Install the balancer shaft holder (see page 7-3).
NOTE: Apply liquid gasket around the oil hole to
the block mating surface.
17. Install the rear balancer weight.
18. Hold the balancer shaft as shown below, then tighten
the bolt.
19. Install the balancer shaft rear cover.
BALANCER SHAFT
REAR COVER
O-RING
Replace.
8 x 1.25 mm
25 N-m (2.5 kgf-m,
18 Ibf-ft)
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)