Acura 3.5 RL Manual page 155

Engine Installation:
Install the engine in the reverse order of removal.
Reinstall the mount bolts/nuts in the following sequence.
Failure to follow these procedures may cause excessive
noise and vibration, and reduce bushing life.
CAUTION: Take care not to damage the rear beam when
installing the engine/transmission assembly.
REAR BEAM
Install the engine so that
the rear beam does not
hit the transmission.
1. Install the transmission mount bracket, then tighten
the mounting bolts.
TRANSMISSION
MOUNT BRACKET
2. Install the transmission mount. Do not tighten the
bolt.
TRANSMISSION
MOUNT
10 x 1.25 mm
38 N-m (3.9 kgf-m,
28 Ibf-ft)
3. Tighten the nut on the right engine mount bracket,
then install the vacuum hose.
VACUUM
HOSE
4. Tighten the nut on the left engine mount bracket,
then install the vacuum hose.
12 x 1.25 mm
64 N-m (6.5 kgf-m,
47 Ibf-ft)
12 x 1.25 mm
64 N-m (6.5 kgf-m,
47 Ibf-ft)
VACUUM
HOSE