Glass/Regulator Removal - Acura 3.5 RL Manual

Glass/Regulator Removal

1. Remove:
Door panel (see page 20-4)
Plastic cover (see page 20-2)
Inner molding (see page 20-2)
2. Carefully move the glass until you can see the bolts,
then remove them. Carefully pull the glass out through
the window slot.
NOTE: Take care not to drop the glass inside the door.
Bolt locations, 2
6 x 1.0 mm
6 N-m (0.6 kgf-m,
4 Ibf-ft)
REGULATOR
GLASS
3. Disconnect the connector, then remove the regula-
tor through the hole in the door.
Bolt locations, 7
6 x 1.0 mm
8 N-m (0.8 kgf-m,
6 Ibf-ft)
Loosen.
REGULATOR
Loosen.
4. Grease all the sliding surfaces of the regulator where
shown.
REGULATOR
5. Installation is the reverse of the removal procedure.
NOTE: Roll the glass up and down to see if it moves
freely without binding. Also make sure that there is
no clearance between the glass and glass run chan-
nel when the glass is closed. Adjust the position of
the glass as necessary (see page 20-16).
CONNECTOR
POWER
WINDOW
MOTOR
Loosen.
POWER WINDOW
MOTOR