Interior Trim - Acura 3.5 RL Manual

Interior Trim

Removal
CAUTION:
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
NOTE: Take care not to bend or scratch the trim and panels.
: Clip, hook locations
FRONT PILLAR TRIM
Remove the grab handle
(passenger's, see page
20-45).
FRONT SIDE
TRIM
HOOK
RIGHT KICK
PANEL
LEFT KICK
PANEL
SLIDER
ROOF SIDE TRIM
FRONT DOOR Remove the grab handle
TRIM (see page 20-45).
REAR DOOR
TRIM
CENTER PILLAR
TRIM
FRONT SEAT BELT
LOWER ANCHOR
(see section
SHOULDER
ANCHOR
ADJUSTER
HOOKS
SLIDER
REAR SIDE
TRIM
REAR SEAT BELT
LOWER ANCHOR
(see section 24)
REAR CENTER SEAT BELT
24)
LOWER ANCHOR
('98-01 models,
see section 24)
Installation is the reverse of the removal procedure.
NOTE:
If necessary, replace any damaged clips.
Before installing the center pillar trim, lower the
shoulder anchor adjuster and the slider of the
center pillar trim fully.
Before installing the anchor bolts and rear pillar
trim, make sure there are no twists or kinks in
the seat belts.
'00 - 01 models: Make sure the child seat tether
anchors are installed securely.
REAR PILLAR TRIM
Remove the rear seat cushion
and rear seat-back (see page
20-67).
REAR SHELF
Remove the rear seat
cushion and rear seat-back
(see page 20-65).
'98 - 01 models:
Remove the center seat belt lower
anchor bolt (see section 24).
'00 - 01 models:
Remove the child seat tether anchors
(see section 24).