Acura 3.5 RL Manual page 629

Torque Converter Housing
Bearings
Countershaft Bearing Replacement
1. Remove the countershaft roller bearing using the
special tool as shown.
SLIDE HAMMER,
3/8" - 16
(Commercially available)
ADJUSTABLE
BEARING
PULLER,
25 - 40 mm
07736-A01000B or
07736-A01000A
2. Install the ATF guide plate.
3. Drive the new bearing into the housing using the
special tools as shown.
0-0.1 mm
(0-0.003 in)
DRIVER
07749-0010000
ATTACHMENT.
62 x 68 mm
07746-0010500
ATF GUIDE PLATE
Transmission Housing
Mainshaft Bearing
Replacement
1. To remove the mainshaft bearing from the trans-
mission housing, expand the snap ring with the
snap ring pliers, then push the bearing out.
NOTE: Do not remove the snap ring unless it's nec-
essary to clean the groove in the housing.
2. Expand the snap ring with the snap ring pliers,
insert the new bearing part-way into it, then release
the pliers. Push the bearing down into the transmis-
sion until the ring snaps in place around it.
NOTE: Install with groove side of the bearing facing
inside the transmission housing.
Remove
MAINSHAFT
BEARING
Install