Manual Mode 1 (Simple Manual Adjustment); Operation Of Manual Mode 1; Adjustment By Manual Mode 1 - Mitsubishi Electric MR-J2S-*A series Instruction Manual

7. GENERAL GAIN ADJUSTMENT

7.3 Manual mode 1 (simple manual adjustment)

If you are not satisfied with the adjustment of auto tuning, you can make simple manual adjustment with
three parameters.

7.3.1 Operation of manual mode 1

In this mode, setting the three gains of position control gain 1 (PG1), speed control gain 2 (VG2) and
speed integral compensation (VIC) automatically sets the other gains to the optimum values according to
these gains.
Therefore, you can adjust the model adaptive control system in the same image as the general PI control
system (position gain, speed gain, speed integral time constant). Here, the position gain corresponds to
PG1, the speed gain to VG2 and the speed integral time constant to VIC. When making gain adjustment
in this mode, set the load inertia moment ratio (parameter No. 34) correctly.

7.3.2 Adjustment by manual mode 1

(1) For speed control
(a) Parameters
The following parameters are used for gain adjustment:
Parameter No.
34
37
38
(b) Adjustment procedure
Step
Set an estimated value to the ratio of load inertia moment to servo
1
motor inertia moment (parameter No. 34).
Increase the speed control gain 2 (parameter No. 37) within the
2 vibration- and unusual noise-free range, and return slightly if vibration
takes place.
Decrease the speed integral compensation (parameter No. 38) within
3
the vibration-free range, and return slightly if vibration takes place.
If the gains cannot be increased due to mechanical system resonance or
the like and the desired response cannot be achieved, response may be
4
increased by
suppression control or machine resonance suppression filter and then
executing steps 2 and 3.
While checking the settling characteristic and rotational status, fine-
5
adjust each gain.
User setting
PG1
VG2
VIC
POINT
If machine resonance occurs, adaptive vibration suppression control
(parameter No. 60) or machine resonance suppression filter (parameter No.
58 59) may be used to suppress machine resonance. (Refer to Section 8.1.)
Abbreviation
GD2
VG2
VIC
Operation
suppressing resonance
GD2
PG2
VG1
Automatic setting
Ratio of load inertia moment to servo motor inertia moment
Speed control gain 2
Speed integral compensation
with adaptive vibration
7 - 7
Name
Description
Increase the speed control gain.
Decrease the time constant of the speed
integral compensation.
Suppression of machine resonance.
Refer to Section 8.2, 8.3.
Fine adjustment