Audio Settings; Audio Defaultvolume; Audio Input Hdmi [1..3] Level; Audio Microphones Mute Enabled - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

Audio settings

Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch
on or restart the video system. Use the Touch controller to change the volume while the
video system is running. You may also use API commands (xCommand Audio Volume) to
change the volume while the video system is running, and to reset to default value.
Requires user role: USER
Default value: 50
Value space: Integer (0..100)
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

Audio Microphones Mute Enabled

Define the microphone mute behaviour on the video system.
Requires user role: ADMIN
Default value: True
Value space: True/InCallOnly
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is
not possible to mute the microphone. This is useful when an external telephone service/
audio system is connected via the codec and is to be available when the codec is not
in a call. When set to InCallOnly this will prevent the audio-system from being muted by
mistake.
D15328.01 SX80 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals Maintenance

Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: USER
Default value: Sunrise
Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.

Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: USER
Default value: 50
Value space: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

Audio Input HDMI [1..3] Level

Define the audio level of the HDMI input connector.
Requires user role: ADMIN
Default value: 0
Value space: Integer (-24..0)
Select a value between -24 and 0, in steps of 1 dB.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
76
Administrator Guide
System settings System settings Appendices