Table of Contents
Advertisement
6. Mount the power strip and PSUs
The power strip and PSUs are placed in the left side module,
close to the bottom.
Don't connect the power strip to the wall socket outlet now.
Power strip and PSUs
1x
Power strip
(Box: Acc 1)
1x
Power strip bracket
(Box: Center kit)
1x
PSU, 12 V
(Box: Acc 1)
1x
PSU bracket
(Box: Center kit)
7x
1x
PSU, 24 V
(Box: Acc 1)
(M4x8, Torx T20)
(Box: Center kit)
D15519.02 | 2024 JANUARY | Cisco Room Kit EQX Installation Guide
6.1. Mount the power strip
Place the bracket over the power strip and fasten it to the
back plate with three screws
(M4x8, Torx T20)
To 12 V PSU (in
step
6.3)
To 24 V PSU (in
step
6.3)
Not in use (intentionally blocked by bracket)
To codec (in
step
6.4)
From wall socket outlet (in
Downward
26
6.2. Mount the PSUs
1. Fasten the PSU bracket to the back plate with four
screws
(M4x8, Torx T20)
.
3x
2. Slide the two PSUs into the bracket. The smaller 12 V
PSU is above the larger 24 V PSU.
The cables that are fixed to the PSUs are to the right.
step
28)
Copyright © 2024 Cisco Systems, Inc. All rights reserved.
.
4x
Advertisement
Table of Contents
