Vega VEGAPULS 63 Operating Instructions Manual page 65

Code Reason
Text message
•
F265
Measurement func-
•
tion disturbed
Function check
Code Reason
Text message
•
C700
Simulation active
Out of specification
Code Reason
Text message
•
S600
Impermissible elec-
tronics temperature
•
S601
Overfilling
Maintenance
Code Reason
Text message
•
M500
Error during the re-
set "delivery status"
•
M501
Error in the non-
active linearisation
table
•
M502
Error in the diag-
nostics memory
VEGAPULS 63 • Modbus and Levelmaster protocol
Sensor no longer carries out a
measurement
Operating voltage too low
The following table shows the error codes and text messages in the
status message "Function check" and provides information on causes
as well as corrective measures.
A simulation is active
The following table shows the error codes and text messages in the
status message "Out of specification" and provides information on
causes as well as corrective measures.
Temperature of the electronics
in the non-specified range
Danger of vessel overfilling
The following table shows the error codes and text messages in the
status message "Maintenance" and provides information on causes
as well as corrective measures.
The data could not be restored
during the reset to delivery
status
Hardware error EEPROM
Hardware error EEPROM
9 Diagnosis, asset management and service
Rectification
•
Check operating voltage
•
Carry out a reset
•
Disconnect operating voltage
briefly
Rectification
•
Finish simulation
•
Wait for the automatic end after
60 mins.
Rectification
•
Check ambient temperature
•
Insulate electronics
•
Use instrument with higher
temperature range
•
Make sure that there is no
further filling
•
Check level in the vessel
Rectification
•
Repeat reset
•
Load XML file with sensor data
into the sensor
•
Exchanging the electronics
•
Send instrument for repair
•
Exchanging the electronics
•
Send instrument for repair
DevSpec
Diagnosis Bits
Bit 11
DevSpec
State in CMD 48
"Simulation Active"
in "Standardized
Status 0"
DevSpec
State in CMD 48
Bit 5 of
Byte 14 ... 24
Bit 6 of
Byte 14 ... 24
DevSpec
State in CMD 48
Bit 0 of
Byte 14 ... 24
Bit 1 of
Byte 14 ... 24
Bit 2 of
Byte 14 ... 24
65