Fc Tracert Commands; Fctracert - HP 6125XLG Command Reference Manual

Field
--- 0xfffc02 fcping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max =
0.889/0.969/1.281 ms

FC tracert commands

fctracert

Use fctracert to detect bidirectional routing information between source and destination. The destination
can be a node or FC switch.
Syntax
fctracert [ -t timeout ] fcid fcid vsan vsan-id
Views
Any view
Predefined user roles
network-admin
Parameters
-t timeout: Specifies the timeout value in seconds for the entire FC tracert process. The value range is 1
to 10 and defaults to 5.
fcid fcid: Specifies the destination address. If the destination is a node, the fcid argument indicates the FC
address of the node. If the destination is an FC switch, the fcid argument indicates the domain controller
address FFFCxx of the switch, where xx is the domain ID of the destination switch. For example, if the
domain ID of the destination switch is 3, its domain controller address is FFFC03.
vsan vsan-id: Specifies an existing VSAN by its ID in the range of 1 to 3839.
Usage guidelines
The bidirectional routing information includes WWNs and domain controller addresses of all switches
on a round trip. The device supports a maximum of 255 hops for a round trip.
To abort the FC tracert operation during the execution of the command, press Ctrl+C.
Examples
# Detect bidirectional routing information between source and destination (a node with FC address
0xd70000) in VSAN 1.
<Sysname> fctracert fcid d70000 vsan 1
Route present for: 0xd70000, press CTRL_C to break.
20:00:00:0b:46:00:02:82(0xfffcd5)
Description
Statistics on the data received and sent in the FC ping
operation.
Number of echo requests sent.
Number of echo replies received.
Percentage of packets not responded to the total number of
packets sent.
Minimum/average/maximum response time, in
milliseconds.
86