Front Wheel - Malaguti SPIDER MAX GT 500 Service Manual

SPIDER MAX 500 - EURO 3
Do not actuate the brake levers without the wheel, as the pads would close.

FRONT WHEEL

REASSEMBLY
When reassembling the wheel, observe rotation
direction, which can be determined by the position
of the spokes of the rim (Please refer: F. 32 - P. 52).
To reassemble the wheel, proceed as follows:
• Insert the wheel in the fork (in the proper direction).
• Insert the wheel spindle (B) and the spacer (B1).
• Insert the spacer (C).
Do not exchange the spacer (B1) with the
spacer (C).
Tighten the spindle (B) to the specified torque.
B
• Tighten the screw (V1) of the wheel spindle clamp.
• Refit the odometer sprocket (pick-up) (A - F. 4) and secure
it by means of the screw (V).
V
1
V
BRAKE MASTER CYLINDERS
Empty the hydraulic system and dispose of the liquid in compliance with the law in force.
Ensure that there are no leaks or splashes of brake liquid, as it is corrosive and may cause personal
injury or damage the motorcycle painted parts.
• Remove the front and rear handlebar cover (S/D - P. 33).
• Release and extract the coupling (A).
• Remove the tube (B) and the gaskets (C).
• Disconnect the Stop switch (S).
45 ± 15%
20 ± 15%
10 ± 15%
V
A
C
F. 4
F. 5
S
F. 6
44 07/06
E
B
B
1
V
1
C
A
B