Rear Arm - Malaguti SPIDER MAX GT 500 Service Manual

SPIDER MAX 500 - EURO 3

REAR ARM

Before removing the rear arm (A), check that the vehicle is in perfectly stable conditions.
After removing the exhaust (the exhaust manifold does not have to be removed) and releasing the shock absorbers,
as described in the previous pages, proceed as follows:
• Release the screw (V) and release the plate securing the
shock absorber (C) from the arm (A).
• Release the nuts (B).
B
V
Remove:
• Anti-vibration O -Ring (1)
• Spilt pin (2)
• Cover (3)
• Release the underlying nut (D).
• Remove the shim (S) and release the arm (A).
D
During the removal and the reassembly of the
rear arm, make sure to place the two spacers
between arm/wheel and arm/nut (D).
SHOCK ABSORBER SUPPORTING PLATE
Right: if the shock absorber and the exhaust have
already been released, in order to remove the
plate supporting the shock absorber (C - F. 104),
simply release the screw (V - F. 104) and remove
the washers and nut.
If the exhaust has not been removed, release
the exhaust upper screw (V3 - F. 98).
33 ÷ 41
30 ± 10%
100 ± 15%
C
V
F. 104
1
3
2
F. 105
NEW
NEW
2
1
F. 106
A
F. 107
80 07/06
V
2
A
V
D
S
3
E
B