Front And Rear Brake Switch; Voltage Delivered To Light Bulb Coupling - Malaguti F12R L.C. 50 cc Workshop Manual

B
Chapter
2. continuity of light bulb and relative coupling
- remove light bulb.
- Connect Tester (Ω) to light bulb.
- Check continuity of light bulb and its coupling.
- Not compliant: replace light bulb or coupling.

3. Front and rear brake switch

- Disconnect switch cables (a).
- Connect Tester (Ω) to terminals (t1-t).
- Check continuity between terminals.
- Not compliant: replace stop switch.
a
F. 3

4. Voltage delivered to light bulb coupling

- Connect Tester (20 V dc) to connector of light bulb coupling, as follows:
- terminal (+) of tester
- terminal (-) of tester
- turn key "ON".
- pull front or rear brake lever
- Voltage delivered to light bulb coupling: > 12 V.
- Not compliant: red cable interrupted. resume connection.
- NOTE: if the grounding connection is interrupted, the rear light will not be working.
F. 36
3
paGe
Signalling System
See "Checking switches" on page 11
red cable (1).
Black cable (2).
See "Wiring Diagram".
1
2
T.1 T.2
1
2
1) Front or rear brake lever
pulled
2) Front or rear brake lever
not pulled
F12R L.C. 50 cc.
Tester (Ω)
Tester (dc 20 V)
0.07
ISSUe