Radiators (Including Lines And Expansion Reservoir) - Malaguti SPIDER MAX GT 500 Service Manual

SPIDER MAX 500 - EURO 3
RADIATORS (including lines and
expansion reservoir)
• Remove the fairing (S/D - P. 24).
• Remove the leg protector (S/D - P. 30).
• Wait for the engine to cool down completely.
• Put a suitable container under the coolant pump (A).
• Remove the clip (B).
• Detach the tube (C) and fit it in the container.
• Remove the cap (D - F. 73) from the expansion reservoir.
• In case radiators have to be removed together with lines,
slacken the clip (B1) and detach the tube (C1).
• Let the liquid completely drain into the container. Pour
the spent liquid in a container suitable for its ecological
disposal.
The coolant is potentially polluting, therefore it
should not be released in the environment.
In case the pump (A) has to be removed, release the
screws (V6).
• Cut the clip (E) securing the electrical fan wiring.
• Disconnect the connector of the electrical fan wiring.
Release the bleed screws (V) on both the radiators,
releasing both ground cable ends (M).
• Cut all the clips securing the lines composing the cooling system circuit.
After refitting any of the components of the cooling system, fix the lines with new clips, in the
same position as before, and fix the ground cable end (M - F. 75) again, both to the right radiator
as well as to the left radiator.
F. 72
F. 73
F. 74
F. 75
66 07/06
C
1
B
1
C
B
A
V
6
D
E
V
M
E