11.
Insert the replacement transmission/alternator assembly into
the machine. Use Velcro strap or zip-tie to secure the trans-
mission pulley assembly to the Frame. Insert the four trans-
mission mounting screws and get them hand tight.
fully tighten them in this step.
12.
Apply Zip-Ties to the wiring harness as shown to route the ca-
bles properly. Install the mylar cover for the LCB with a philips
screwdriver.
13.
Use a 7/16" socket or adjustable wrench to secure the trans-
mission bracket to the transmission.
Once the drive chain is around sprockets, tighten the four
transmission mounting screws
DO NOT
Page 88