Signal Flow
All TV/Cable signals in the 8G are pass-through signals to the console. Coax cable for TV signals is plugged into the lower
right leg of the 8G and connects to an internal coax cable that goes through the head to the console.
8G Gauntlet Signal Flow
Alternator
P/N 711-3361
RPM Sensor
P/N 140-3501
Battery 6VDC
P/N 580-0275
Refer to OpenHub Manual
For Troubleshooting
Alt Cable Harness
Main Data Cable P/N 711-3494
P/N 711-3351
LCB P/N 711-3461
Control Signal to/from Display
To Display
Coax Cable P/N 711-3499
To Display
To Display
C-Safe Cable P/N 711-3500
This coax cable does not interact with the internal electrical components of the 8G. Other than TV signals, the only
other signals passed within the unit are control signals from the LCB to the drive components and the console. See the
diagram above.
To troubleshoot a signal within the 8G test the continuity of the wire. If the wire is continuous and signal issues still
result, please refer to the
OpenHub Service Manual
for advanced troubleshooting.
Page 23