To replace the component, reverse the removal procedure.
Removing and replacing the D6020 power block
To remove the component:
1.
Power down the D6020 (see
2.
Disconnect all cables.
3.
Remove all power supplies (see
(page
24)).
4.
Remove all fan modules (see
5.
Remove all I/O modules (see
(page
23)).
6.
Release the hard drive drawers:
a.
Pull down the handle on the front of the drawer, but do not extend the drawer.
b.
Push up and hold the two release mechanisms on the I/O bays, and then move the
drawer forward about 15 cm (6 in).
Figure 11 Pushing up the release mechanism on the I/O bays
Figure 12 Moving the hard drive drawer forward
"Powering down" (page
"Removing and replacing the D6020 power supply"
"Removing and replacing the D6020 fan" (page
"Removing and replacing the hot-pluggable I/O module"
Removing and replacing the D6020 power block
18)).
22)).
25