Removing And Replacing The Hard Drive And Hard Drive Blank; Removing The Hard Drive Or Hard Drive Blank; Replacing The Hard Drive - HPE D6020 Maintenance And Service Manual

Removing and replacing the hard drive and hard drive blank

Removing the hard drive or hard drive blank

CAUTION:
all bays are populated with either a hard drive or a blank. Remove a blank only if a drive is ready
to install or the D6020 is powered down.
To remove the component:
1. Extend the hard drive drawer (on
2. Remove the hard drive or hard drive blank.
Figure 2 Removing the hard drive blank

Replacing the hard drive

CAUTION:
extend the hard drive drawer no more than 10 minutes. Do not operate the D6020 unless all
bays are populated with either a component or a blank. Remove a drive only if another drive is
ready to be installed or the D6020 is powered down.
Before replacing a hard drive, do the following:
Verify the status of the drive to be replaced by reviewing the hard drive LEDs (see
"Understanding hard drive LEDs" (page
"Understanding hard drive LED combinations" (page
Check the RAID status and configuration to be sure data loss does not occur if the drive is
removed. For more information, see the HPE Smart Storage Administrator User Guide on
the HPE website at http://www.hpe.com.
Be sure that the replacement hard drive is the same interface and the same or larger capacity.
20 Removal and replacement procedures
To prevent improper cooling and thermal damage, do not operate the D6020 unless
To prevent improper cooling and thermal damage, for standard FRU removal,
"Extending the hard drive drawer" (page
38)) and hard drive LED combinations (see
38)).
19)).