Removing And Replacing The D6020 Fan - HPE D6020 Maintenance And Service Manual

2. Fully extend the hard drive lever, and push the hard drive all the way into the drive bay, and
then close the lever.
Figure 6 Installing the hard drive

Removing and replacing the D6020 fan

IMPORTANT:
cord label, require that the power cord be removed before removing the fan.
Before removing a fan, note the following:
Replace only one fan at a time. Fans are N+1 redundant.
Be sure to verify that other fans are installed and that their LEDs are green before replacing
a fan.
Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (see
"Understanding rear panel LEDs and buttons" (page
Be sure that your configuration can support your actions. If the proper redundancy is not in
place, power down the D6020 before beginning this procedure.
All other fans must be installed for proper redundancy.
To remove the component:
1. Be sure that the hard drive drawer is closed.
2. Remove the fan.
Figure 7 Removing the D6020 fan
CAUTION:
minutes while the system is powered on and more than one component or blank is removed.
After removing an active component, promptly replace it with a blank or the appropriate
component.
To replace the fan, install it into the fan bay, and push until it locks into place.
22 Removal and replacement procedures
Configurations using power cord part number 142263-004, located on the power
For best cooling practices, do not operate the enclosure for more than 10
36)).