Removing And Replacing The D6020 Hard Drive Drawer; Removing The D6020 Hard Drive Drawer - HPE D6020 Maintenance And Service Manual

Figure 15 Removing the D6020 power block
10. While supporting the power block, disconnect the signal and power cables on each side of
the power block.
Figure 16 Disconnecting the power block signal and power cables
To replace the component, reverse the removal procedure.
NOTE: Power on the system in the following manner:
1. Make sure only the primary I/O module is inserted.
2. Power on the system.
3. Wait until the primary I/O module is ready (less than 1 minute).
4. Insert the secondary I/O module .

Removing and replacing the D6020 hard drive drawer

Removing the D6020 hard drive drawer

To remove the component:
1. Power down the D6020 (see
2. Disconnect all cables.
"Powering down" (page
Removing and replacing the D6020 hard drive drawer
18)).
27