Table of Contents
Advertisement
Installation
Replacing the alignment pins on the rail kit
The rail kit ships with preinstalled alignment pins on each outer cabinet member rail. The alignment pins—also known as
bosses—support the weight of the system during the installation process. To ensure that the alignment pins fit snugly
into the rack, check their size.
HPE racks require that the 8.9 mm alignment pins are installed in the rail kit for the J2000. Of the available alignment
pins shipped with the system, the 8.9 mm pins have a larger head size than the 7.1 mm and 9.5 mm pins. If your rail kit
does not come preinstalled with the 8.9 mm alignment pins, replace them as described in this procedure.
Procedure
1. Remove the two preinstalled 9.5 mm alignment pins from the bracket on each front outer cabinet member rail.
2. Install the four 8.9 mm alignment pins, two on each of the brackets on the front outer cabinet member rail.
3. Duplicate these steps for the alignment pins on the back of each rail.
There are a total of four pins per rail.
Separating the rail kit inner and outer rails
Procedure
1. Slide the inner chassis member rail out from the outer cabinet member rail until it it cannot slide any further.
2. Pull the release tab on the inner chassis member rail forward.
3. Pull the inner chassis member rail from the outer cabinet member rail and set it aside.
4. Repeat the preceding steps to separate the second inner chassis member rail from the outer cabinet member rail.
1
1
2
2
Installation
9
Advertisement
Table of Contents
