When The Scanner Is Not Detected Automatically (Supplementation) - Fujitsu TWAIN 32 Manual

3.5 When the scanner is not detected automatically (Supplementation)

During the procedures given in the section 3.2.1 to 3.2.4, if the scanner is not detected
automatically immediately after turning the power on, open the property of the [System]
in the [Control Panel] to display the list of [Device Manager] and confirm the registration
condition of the scanner.
- If the scanner is registered under [Other devices].
The scanner is registered with the driver installed improperly.
Select the scanner and click the [Delete] button to once delete the registration
(or right-click and select the [Delete]). When restarting the system, the
scanner is detected automatically. Install Mini Driver following the procedure
of each OS given in the section 3.2.1 to 3.2.4.
- If the scanner is registered under [Imaging devices]
A driver of previous version may be installed.
Update the driver following the procedures of each OS given in 3.2.5 to 3.2.8.
- The scanner is not registered anywhere.
The scanner may not be installed correctly.
Reconfirm whether the power of the scanner is turned on, the scanner has
been activated correctly or the scanner is connected to the personal
computer correctly.
- NOTE
If the EZ-SCSI of Adaptec has been installed, the "new hardware wizard"
may not be displayed on startup and it may cause install failure.
In this case, please uninstall the EZ-SCSI and restart the PC before install
the driver.
50