Camera Interface; Connections; General Description - Basler A202K Manual

2 Camera Interface

2.1 Connections

2.1.1 General Description

The A202 is interfaced to external circuitry via two connectors located on the back of the camera:
k
• a 26 pin, .050" Mini D Ribbon (MDR) female connector used to transmit video data, control
signals, and configuration commands.
• a 6 pin, micro-miniature, push-pull receptacle used to provide power to the camera.
A status LED located on the back of the camera is used to indicate power present and signal
integrity. Figure 2-1 shows the connectors and the LED.
LED
Figure 2-1: A202
k
BASLER A202
DRAFT
Connectors and LED
k
Camera Interface
Micro-miniature
6 Pin Receptacle
26 Pin Female
MDR Connector
2-1