Exposure Time Control Mode - Basler A202K Manual

4.2.4.2 Exposure Time Control Mode

Purpose:
Type:
Read Command:
Response:
Write Command:
Response:
Data Format:
k
BASLER A202
To set the exposure time control mode or to read the current exposure time control mode
setting. See Section 3.2 for an explanation of exposure time control modes.
This is a read or write command.
Cmd-ID
0xA0
Cmd-ID
0xA0
Cmd-ID
0xA0
None
Byte 1
ID Exposure Time Control Mode
0x00 Free-run, Programmable
0x04 ExSync, Level-controlled
0x05 ExSync, Programmable
DRAFT
R/W-Flag Data Length
1
R/W-Flag Data Length
0
R/W-Flag Data Length
0
An ID that specifies the exposure mode
(see the table below).
Configuring the Camera
Data
1 -
Data
1 1 Byte
Data
1 1 Byte
4-11