The LEDs for CO/IP line buttons flash at distinctive rates for the holding
station and other iPECS Phone users.
There are also user operations such as pressing a DSS/BLF button that will
place a call in Automatic Hold.
Calls will remain in the held state for a period and then recall the user.
This Hold Recall is provided with a different ring signal. If not answered in
a timely manner, the Attendant will receive Attendant Hold Recall.
To place a call on Hold:
Press the HOLD(SAVE).
5.3
Broker Call: Switching between two calls
You may switch between the active call and a call on Hold, placing the
active call on Hold acting as a broker between two or more parties (Broker
Call). iPECS Phone users may 'broker' for multiple calls up to the number
of CO/IP line buttons.
To switch between two calls (Broker Call):
Press the desired CO/IP line button.
5.4
Joining Multiple People in a Conference
You can establish a Conference with up to 3 parties, or 32 parties when
using a Multi-Party Conference Interface Module (MCIM). The other parties
in the Conference may be internal or external.
A Conference can be placed on Hold and is subject to Hold Recall.
You may also use the Conference operation to join 2 external parties in a
private conversation. This is an Unsupervised Conference, which is not
subject to the normal Hold Recall operation.
To establish a Conference:
Establish call with one of the desired conference parties,
Select the CONF Soft button, (in case of LIP-9010, use the programmed
CONF Flex button instead of the CONF Soft button)
Establish call with the other conference party,
Select the CONF Soft button,
Select the CONF Soft button again to establish the conference.
To place a Conference on Hold:
42
LIP-9000 Series User Guide - ST