Table of Contents
Advertisement
status information. SLP settings can be specified via the Remote UI. This section also describes the procedure to
configure settings for communication between the machine and plug-ins for imageWARE Enterprise Management
Console.
*
For more information about imageWARE Enterprise Management Console, contact your local authorized Canon dealer.
To use imageWARE Enterprise Management Console plug-ins
●
You need to enable the settings of the dedicated port and the SNMP settings. As for the SNMP settings, set
[MIB Access Permission] to [Read/Write] for both SNMPv1 and SNMPv3.
<Use Dedicated Port>(P. 462)
Monitoring and Controlling the Machine with SNMP(P. 68)
Remote UI Operations
●
For more information about the basic operations to be performed when setting the machine from the
Remote UI, see
Setting Up Menu Options from Remote UI(P. 427) .
◼
Configuring SLP Communication with Device Management Software
1
Start the Remote UI and log in to System Manager Mode.
UI(P. 419)
2
Click [Settings/Registration] on the Portal page.
3
Click [Network Settings].
4
Specify SLP settings.
Specifying multicast device discovery
1
Select [Multicast Discovery Settings]
2
Select the [Respond to Discovery] check box and specify the required settings.
[Respond to Discovery]
Select the check box to set the machine to respond to device management software multicast discovery
packets and enable monitoring by device management software.
Setting Up
Remote UI Screen(P. 420)
[Edit].
74
Starting Remote
Advertisement
Table of Contents
