Table of Contents
Advertisement
2
Spread the slide guides apart.
●
Slide the slide guides outward until they are slightly farther apart than the actual original width.
3
Fan the original stack and align the edges.
●
Fan the original stack in small batches, and align the edges by lightly tapping the stack on a flat surface a few
times.
4
Place the original(s) face up in the feeder.
●
Make sure that the original stack does not exceed the load limit lines (
●
Do not load originals of various sizes at the same time.
●
If originals are loaded so that they exceed the load limit line, scanning may stop or a paper jam may occur.
5
Align the slide guides against the edges of the original.
●
Slide the slide guides inward until they are aligned securely against the edges of the original.
➠
The machine is ready to scan the original.
Basic Operations
137
).
Advertisement
Table of Contents
