Blocking Jobs When Department ID Is Unknown(P. 360)
#703
Data could not be written because the memory space that was allocated for images was full when
sending an e-mail/I-Fax or storing to a shared folder/FTP server.
●
If another sending document is queued, wait for a while until it is completed, and send again.
●
Divide the document into multiple sections before sending.
●
Delete the documents that are stored in memory.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
#751
The FTP server has not been started up or a network connection has been cut.
(Failure to connect to the destination is sometimes caused by a disconnection en route.)
●
Check the destination.
●
Check the network status.
Viewing Network Settings(P. 37)
The IP address was not set correctly.
●
Check <TCP/IP Settings>.
Setting IP Addresses(P. 30)
#752
E-mail sending or I-Fax sending/receiving was impossible because an incorrect SMTP/POP3 server name
was set.
●
Check the SMTP/POP3 server name, and correct the setting.
Configuring Basic E-Mail Settings(P. 86)
Configuring E-Mail/I-Fax Communication Settings(P. 89)
E-mail sending or I-Fax sending/receiving was impossible because an incorrect domain name was set.
●
Check the domain name, and correct the setting.
Configuring DNS(P. 55)
E-mail sending or I-Fax sending/receiving was impossible because the machine was not connected to a
network correctly.
●
Check whether the machine is properly installed and correctly connected to the network.
Installation/Settings Problems(P. 617)
#753
Scanned data could not be sent as e-mail, not sent/received as I-Fax, or not stored in the shared
folder/FTP server because the LAN cable is disconnected.
Troubleshooting
661