Technogym Recline 500SP Service Maintenance Manual page 85

RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1) Check that the 6 screws fixing the disk brake to the flywheel are all locked down.
The speed sensor detects the heads of these screws.
(2) Place the tester probes across the terminals of the speed sensor. The measured signal should
be that indicated in Figure 3.2-1. In addition, when pedaling at 80 RPM the frequency of the
signal should be 107 Hz.
The speed signal can also be observed qualitatively, using a multimeter. The value
should be 0 Vdc when the machine is stopped, and gradually increase as the speed
increases.
(3 ) Launch the default setting for the low kit parameters.
(4) Update the low kit SW uploading both firmware and brake table. At the end launch the
default setting for the low kit parameters.
Page 6.25