Technogym Recline 500SP Service Maintenance Manual page 122

Figure 7.13-3
Page 7.28
RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Disassembling the brake pulley c:
6. Unscrew the brake pulley c using a 17-mm
wrench, using a 6-mm Allen wrench to hold
the shaft in place on the opposite side.
To reassemble the brake, carry out the above
steps in reverse order.
Remember to fully lock down all the
screws "b" (in a cross pattern), as they
may knock against the speed sensor if
left loose. Lock down the screws using a
torque wrench set for 6 Nm.
After reassembling the brake, use a
comparator to check for any curvature
of the copper disk, with a margin of ±
0.15 mm.
Lock down the screw "c" using a torque
wrench set for 40 Nm.