Technogym Recline 500SP Service Maintenance Manual page 55

RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Figure 4.5-9
Figure 4.5-10
23. Plug the lower end of cable 8 (CB-18) into
union connector 7, previously assembled on
connector plate 6.
24. Fix CSafe connector g, if present, to
connector plate 6.
25. Snap connector plate 6 into its seat on the
platform.
26. Reassemble the cover that was removed
previously.
27. Turn the machine back upright.
28. Insert cable 8, routing it toward the display
alongside the group of cables which connect
the upper and lower parts of the machine.
More specifically insert it into the left part of
the 2 column sections.
29. Use a cable tie to attach cable 8 to the
existing group of cables.
30. Reassemble the
disassembled previously.
31. Reassemble the seven pins rom that was
disassembled previously
Route the cable (8) along the back as
indicated in the box.
32. Reassemble the right guard that was
disassembled previously.
During reassembly, lock down the
screws (c) using a torque wrench set for
0.8 Nm.
33. Reassemble the bottle holder that was
disassembled previously.
Continued on following page →
left guard that was
Page 4.9