RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Figure 4.5-5
Figure 4.5-2
Figure 4.5-3
7. On the right side, back off the 7 screws c
using a 4-mm he
x T-wrench.
8
. Position the right pedal at the top and remove
the right guard.
This operation may be awkward. If in
difficulty,
perform
procedure which involves disassembling
the right pedal crank and then removing
the right guard.
9. Remove the seven pins rom o the left guard.
10.
Remove the left guard.
11. Unplug the connectors indicated in the
figure.
12. Back off the two screws p using a 4-mm
allen-T wrench.
13. Remove the brake board n.
14. Assemble the brake board 12, included in the
kit.
15. Connect all the connectors previously
disconnected from the brake board.
During assembly, lock down the screws
"m" using a torque wrench set for 5 Nm.
Continued on following page →
the
standard
Page 4.7