Technogym Recline 500SP Service Maintenance Manual page 129

RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Only 700i, 700i SP and 700iE models
Figure 7.18-2
Figure 7.18-3
Figure 7.18-4
1. Move the saddle into position 8.
2. Protect the equipment frame using a cloth as
shown in the figure.
3. On both side, disassemble the 2 pulleys on
which the saddle moves, backing off the nut
a using a 17-mm wrench and locking down
the eccentric pin b using a 24-mm wrench.
4. T urn the saddle over its back as shown in the
fi gure.
5. Pay attention that the saddle stays over the
cloth and that the hand sensor interface board
cable is not t oo tight.
7. Back off the two fixing screws c of the cable
holder, using a 2.5-mm Allen wrench.
During reassembly, lock down the
screws "c" using a torque wrench set for
3 Nm.
Continued on following page →
Page 7.35