Select the model name of the machine on hand, and then click Cut.
If the model name is not displayed, see
The cutting data is sent to the machine. When the machine receives the data, it automatically reads
the crop marks using a sensor, and then starts cutting.
Crop Marks Cannot Be Read
If the Sensor Fails to Read the Crop Marks
If the sensor fails to read the crop marks, the screen in the figure appears. If this screen appears,
proceed to
"Crop Marks Cannot Be Read."
Mode (1),"
and then perform positioning in tool mode.
When cutting is finished, click Exit to close the window.
To Cancel Cutting
Remove the cut material.
Remove the material to complete the cutting procedure.
"The Machine Doesn't Run"
If this does not resolve the issue, refer to
in "Troubleshooting."
"Cutting in Tool